Refrigerators are the backbone of your kitchen. They are usually durable and long-lasting, but when they go down, you have to have them fixed right away. Some tips on replacing the fan motor in your commercial refrigeration unit:
There are two types of motors for refrigeration.
1. Condenser fan motor.
2. Evaporator fan motor.
First, we will discuss the condenser fan motor:
The condenser fan motor is mounted on the condensing unit located outside the refrigeration interior. The size of the refrigerator unit will determine the motor size. Motors vary in size, voltage and rotation. All of this information is found on the motor, and is very important to have when ordering. Rotation is vital to the operation of the unit. Rotation will either be clockwise (CW) or counter-clockwise (CCW).
The fan blade is also a critical part of the motor. The blade is similar to the motor in that it is either CW or CCW. Normally the rotation of a fan blade is stamped into the blade assembly. When replacing either the motor or the fan blade be sure to use the same rotation type.
Next, we will discuss the evaporator fan motor:
The evaporator is located inside the refrigeration interior, and will always be located on the ceiling or top of the unit. There are two types of evaporative motors:
1. Open winding type.
2. Closed type.
On the open winding motor the copper wires are exposed and visible to the eye. The open winding motors are usually reversible. This is done by removing the bearing housing and pulling out the armature. The armature is the part that has the fan blade attached to it. Simply turn it around and put the shaft through the other direction and reassemble. Now you have gone from CW to CCW motor or a CCW to a CW. Each manufacturer will vary in what direction their motors rotate.
The closed winding motor has an encasement around it. The rotation will be stamped on the back of the motor. Mounting holes will be either on the side or rear of the motor. If the motor fails, the motor will need to be replaced and cannot be repaired.
Buy general use fan motors or search by manufacturer here.
As with every piece of equipment the most important thing is the model and serial number on the equipment itself. Generally, the model and serial numbers are found in the interior of an upright cooler/freezer, prep table or under counter cooler/freezer. If the condensing unit is attached to one side or the other of the unit, the model and serial numbers may be found inside that area.